Frankenslot Carrera Digital Slot Car Controller
• Wireless
• Perfect controller for Carrera Digital Set
• Launch Control
• 3 Speed Levels
• Acceleration Curve
• Operates with 3 AAA batteries (not included) - run-time for over 84 hours (9 months in stand-by)
• New lane-change button



OPERATING INSTRUCTIONS:
Setting the channel to use and connect with the receiver:
Switch the controller off. Recipient select the desired channel to the Carrera. During power-up hold the switch button on the controller. Receiver acknowledges the programming with the "7-segment run". Controller ready to go.
The configuration mode
Control was connected with receiver. Switch the controller off. Regulator gas completely by pressing hold and hold switch button and then turn on controller. LED goes on. To let go of the switch button and trigger the configuration begins.
The configuration is done based on the SpeedFlow box programming
The selection of the desired configuration value is done by briefly pressing of the switch button. Storing the value selected is carried out by the LED hold acknowledged storing the Lanechange-button, to a rapid Flash. After that, the next configuration option is indicated by flashing. The following configuration options are available.
Number of speed levels
- 1 x Flash - original Carrera 16 speeds
- 3 x Flash - Speedflow regulation 30 speeds
- 4 x blinking - Speedflow Regulation 44 speed steps
Selection: press
Save: pressing, until LED flashes rapidly.
Launch control active or switched off
- 1 x deactivated
- 2 x flashing launch control is available
Selection: press
Save: pressing, until LED flashes rapidly.
Select performance curve
Here, the translation of the trigger position in the performance level of the car can be set. Specifies the number of flashes which curve is selected.
Selection: press
Save: pressing, until LED flashes rapidly.