Vintage Motors and Parts
With copper pigtail, will also fit ANY Mabuchi FT16, FT16D & FT26 motors, improves conductivity and reduces heat and wear, set more info
$6.00
This motor fits all Cox "Team Modified" magnesium-chassis cars, the Cox Lola T70 (sidewinder version), Ford Galaxie stocker as well as the Chaparral 2E with magnesium chassis. ... more info
$39.95
Out of Stock
Increase your Mabuchi FT16D ("16D") motor performance with these Cox brushes and springs. The brushes have a high content of silver, allowing more current to be transmitted to the... more info
$4.95
French Motor Co. was a distributor for Mura Products and there is little doubt that these beautiful arms were wound for them by the famous motor company. These double 28-29 arms are ideal for fast... more info
$34.95
Out of Stock
French Motor Co. was a distributor for Mura Products and there is little doubt that these beautiful arms were wound for them by the famous motor company. These single-26 armatures wound in 1967 are... more info
$39.95
Great Mabuchi FT36D motor with pinion and original lead wires, fits most 1960's cars, NOS. Colors may vary. You may request plain silver (Revell, Unique, Dugan's...) or red (Monogram X220) or... more info
$24.95
By Classic, will fit any Mabuchi FT36 and FT36D motor such as K&B Hellcat , Cox NASCAR, Cox TTX200 etc. The pinion will fit on the end bell side. more info
$9.50
Hard to find genuine motor brushes for your vintage Mabuchi FT16D motors, re-badged by many manufacturers. These brushes will fit the FT16D ("16D") as well as FT26 ("26D") ... more info
$4.95
Unpainted, two-hole design with clearance for anglewinder can-side drive mount (can bearing not supplied) as used by all the West Coast pros from 1970 to 1977, NOS, hard to find, C10 more info
$24.95
New old stock, includes 1972-on fitted larger oilite bearing (no other hardware supplied) fits much of the currently available hardware, notched for chassis main-rail clearance, very hard to find, C10 more info
$29.99
New old stock, includes 1972-on fitted larger oilite bearing (no other hardware supplied) fits much of the currently available hardware, notched for chassis main-rail clearance, very hard to find, C10 more info
$29.99
New old stock, includes 1972-on fitted larger oilite bearing (no other hardware supplied) fits much of the currently available hardware, notched for chassis main-rail clearance, very hard to find, C10 more info
$29.99
New old stock, includes 1972-on fitted larger oilite bearing (no other hardware supplied) fits much of the currently available hardware, notched for chassis main-rail clearance, very hard to find, C10 more info
$29.99
Wound for REH by Rocket Armatures, this vintage 26-single arm has a drill blank shaft, CCW rotation and is epoxied, trued and dynamically balanced. Fits in all 16D-size motors as well as all C-cans.... more info
$39.95
225' of this great rewinding pue copper wire with great high-temp polythermalese insulation to use on one of the FT16, FT26 or FT36 armature stacks sold in this catalogue. Recommendation:... more info
$9.95
These insulating plates fit at ach end of a FT26 ("26D" armature stack and are a must for rewinding such an arm. old in pair, NOS. more info
$2.95
